1996 Mitsubishi Diamante Tire Pressure

Recommended tire pressure for 1996 Mitsubishi Diamante tires to improve fuel efficiency, extend tire life and drive safely.

1996 Mitsubishi Diamante comes in 1 trim and 1 original equipment tire size set with recommended tire inflation of 26 psi to 32 psi.

1996 Mitsubishi Diamante ES

Front Tire Rear Tire
Tire Size 205/65R15 205/65R15
Recommended Tire Pressure 32 psi (2.2 bar or 221 kPa) 26 psi (1.8 bar or 179 kPa)
Acceptable Winter Tire Pressure 35 - 37 psi 29 - 31 psi
Tire Size Type Metric Metric
Tire Load Index
Tire Load Capacity
Tire Speed Rating V V
Maximum Tire Speed 149 mph (240 km/h) 149 mph (240 km/h)
Save Money on Tire Products

All tire pressure information listed is for informational purposes only. TirePressure.com does not warrant or make any representations regarding the use of or the results of the use of this information. Always refer to your vehicle owner's manual for proper tire inflation pressures.

It is vital to maintain proper tire inflation pressures for 1996 Mitsubishi Diamante tires. Low tire pressure and underinflated tires can lead to uneven and excessive tire wear, poor handling and reduced fuel economy. High tire pressure and overinflated tires can result in reduced traction, poor braking and can even be a cause of a tire blowout. Check tire pressure regularly and maintain correct tire inflation for 1996 Mitsubishi Diamante to enjoy a safe and comfortable drive.

Recommended tire pressure for 1996 Mitsubishi Diamante is determined by the manufacturer based on its characteristics and original equipment tire sizes. You can find 1996 Mitsubishi Diamante recommended tire pressure in owner's manual or on a tire placard on the side of driver's door or door jam. 1996 Mitsubishi Diamante tire inflation will be listed in psi (pounds per square inch), bar or kPa (kilopascals). Keep in mind that tire inflation listed on tire sidewall is the maximum air pressure the tire can hold to carry its maximum load, and not necessarily the recommended tire pressure for 1996 Mitsubishi Diamante. Your 1996 Mitsubishi Diamante may also have different recommended tire pressure settings for front and rear tires, especially if equipped with staggered tires.

To check 1996 Mitsubishi Diamante tire pressure you will need to know its recommended tire inflation and a tire pressure gauge. Check tire pressure when tires are "cold" using quality tire pressure gauge. Adjust 1996 Mitsubishi Diamante tire inflation to the recommended tire pressure settings as needed by adding or releasing air.

If you replace 1996 Mitsubishi Diamante original equipment tires and switch to different tire size, make sure to follow guidelines for the application of load and inflation tables to find proper tire pressure for new tires. Always refer to the 1996 Mitsubishi Diamante owner’s manual for any specific safety advice regarding the application of replacement tires.

1996 Mitsubishi Diamante tire pressure fluctuates with ambient temperatures, so when temperatures drop tires may lose approximately 1 psi of air pressure for every 10 degree Fahrenheit decrease in temperature. During winter 1996 Mitsubishi Diamante tires can be inflated 3 to 5 psi above the recommended tire pressure settings to compensate for lower temperatures. Make sure to check tire pressure regularly in the winter to keep tires properly inflated for a safe ride on snow and icy roads. Consult owner's manual for recommended winter tire pressure for your 1996 Mitsubishi Diamante.

If your 1996 Mitsubishi Diamante is made after 2007, it should be equipped with tire pressure monitoring system that uses tire pressure sensors to alert the driver when tire pressure is low. If 1996 Mitsubishi Diamante low tire pressure warning light is on, check all tires for low air pressure and inflate as needed. If you need to reset TPMS, refer to owner's manual on how to reset 1996 Mitsubishi Diamante tire pressure monitoring system.