1988 Bentley Mulsanne Tire Pressure

Recommended tire pressure for 1988 Bentley Mulsanne tires to improve fuel efficiency, extend tire life and drive safely.

1988 Bentley Mulsanne comes in 1 trim equipped with 1 original equipment tire size set with recommended tire inflation of 24 psi to 28 psi.

1988 Bentley Mulsanne S Tire Pressure

Front Tire Rear Tire
Tire Size 235/70R15 235/70R15
Recommended Tire Pressure 24 psi (1.7 bar or 165 kPa) 28 psi (1.9 bar or 193 kPa)
Acceptable Winter Tire Pressure 27 - 29 psi 31 - 33 psi
Tire Size Type Metric Metric
Tire Load Index
Tire Load Capacity
Tire Speed Rating H H
Maximum Tire Speed 130 mph (210 km/h) 130 mph (210 km/h)

All tire pressure information listed is for informational purposes only. TirePressure.com does not warrant or make any representations regarding the use of or the results of the use of this information. Always refer to your vehicle owner's manual for proper tire inflation pressures.

Bentley Tire Pressure | Bentley Mulsanne Tire Pressure | 1988 Bentley Tire Pressure

It is vital to maintain proper tire inflation pressures for 1988 Bentley Mulsanne tires. Low tire pressure and underinflated tires can lead to uneven and excessive tire wear, poor handling and reduced fuel economy. High tire pressure and overinflated tires can result in reduced traction, poor braking and can even be a cause of a tire blowout. Check tire pressure regularly and maintain correct tire inflation for 1988 Bentley Mulsanne to enjoy a safe and comfortable drive.

Recommended tire pressure for 1988 Bentley Mulsanne is determined by the manufacturer based on its characteristics and original equipment tire sizes. You can find 1988 Bentley Mulsanne recommended tire pressure in owner's manual or on a tire placard on the side of driver's door or door jam. 1988 Bentley Mulsanne tire inflation will be listed in psi (pounds per square inch), bar or kPa (kilopascals). Keep in mind that tire inflation listed on tire sidewall is the maximum air pressure the tire can hold to carry its maximum load, and not necessarily the recommended tire pressure for 1988 Bentley Mulsanne. Your 1988 Bentley Mulsanne may also have different recommended tire pressure settings for front and rear tires, especially if equipped with staggered tires.

To check 1988 Bentley Mulsanne tire pressure you will need to know its recommended tire inflation and a tire pressure gauge. Check tire pressure when tires are "cold" using quality tire pressure gauge. Adjust 1988 Bentley Mulsanne tire inflation to the recommended tire pressure settings as needed by adding or releasing air.

If you replace 1988 Bentley Mulsanne original equipment tires and switch to different tire size, make sure to follow guidelines for the application of load and inflation tables to find proper tire pressure for new tires. Always refer to the 1988 Bentley Mulsanne owner’s manual for any specific safety advice regarding the application of replacement tires.

1988 Bentley Mulsanne tire pressure fluctuates with ambient temperatures, so during winter when temperatures drop tires may lose approximately 1 psi of air pressure for every 10 degree Fahrenheit decrease in temperature. Some vehicle manufacturers may recommend inflating tires 3 to 5 psi above the recommended tire pressure settings to compensate for lower temperatures during winter. Make sure to check tire pressure more often in the winter to keep tires properly inflated for a safe ride on snow and icy roads.

If your 1988 Bentley Mulsanne is made after 2007, it should be equipped with tire pressure monitoring system that uses tire pressure sensors to alert the driver when tire pressure is low. If 1988 Bentley Mulsanne low tire pressure warning light is on, check all tires for low air pressure and inflate as needed. If you need to reset TPMS, refer to owner's manual on how to reset 1988 Bentley Mulsanne tire pressure monitoring system.